GALAXIS SHOWTECHNIK PYROTEC L-Flame Flame Head User Manual page 23

1, 2 Carrying handles
3 Tank inlet
4 LED bargraph filling level
5 Bubble level
6 Lemo socket Refuel Station
7 Hydraulic connection Refuel
Station
8 LC Display
9 LED 'Operation'
10 LED 'Charging'
11 LED 'Low Battery'
12 LED 'Fault'
13 Magnetic sensitive area 'Up'
14 Magnetic sensitive area 'Down'
15 Magnetic sensitive area 'Mode'
16 DMX input and output,
XLR 5-pin
17 DMX input and output,
XLR 3-pin
18 Main switch
19 Connector for emergency off
switch
20 Hydraulic connection Empty
Tank
21 Connector for Charging Unit,
XLR 3-pin
22 Connector Tank Vent
23 Lemo socket Flame Head Power
Supply
24 Lemo socket Flame Head Data
Cable
25 Hydraulic connection Flame
Head Fuel Supply
26 Housing foot
23
The handles are on both sides and they are intended to lift
and carry the device by two persons.
Here, the sealing cap is to be screwed on, which is only
removed during filling.
A sensor field for the magnetic pen is used to activate the
measurement.
Serves to align the device on level stand. The air bubble must
be in the inner ring. Only then is the operation safe.
The data cable of the Refuel Station is connected here.
The fuel hose of the Refuel Station is connected here.
Displays the current information.
This blue LED is continuously on if the device is in the menu
and it is flashing if the device is in stand-by mode or ready to
fire.
This green LED is lit if the device is being charged.
If the battery is discharged below 30% this red LED is
flashing in stand-by mode or if the device is ready to fire.
Lights up red when there is a fault.
For changing the parameter currently shown in the display.
In standby mode, it can be used to select various displays. In
the menu, this control element is used to increase a
parameter or select a function (Yes).
For changing the parameter currently shown in the display.
In standby mode, it can be used to select various displays. In
the menu, this control element is used to decrease a
parameter or not to select a function (No).
To call the menu and to go to the next menu item. Also 'Do
not change and continue' and thus partly identical with
'Down'.
Use either this or the other input or output. The inputs are
connected internally, as are the outputs.
Use either this or the other input or output. The inputs are
connected internally, as are the outputs.
Switching off should normally only take place in standby
mode.
Connect the Emergency Stop switch here. No operation is
possible without the Emergency Stop switch in the 'On'
position.
A hose can be connected here if fuel is to be pumped back
into a container.
For connecting the supplied charger.
A hose can be connected here to vent the produced fuel
vapors to a safe area.
three adjacent present for Flame Head 1 to 3
three adjacent present for Flame Head 1 to 3
three adjacent present for Flame Head 1 to 3
six times in total present on the underside of the housing