GALAXIS SHOWTECHNIK PYROTEC L-Flame Flame Head User Manual page 39

Table of Contents

Advertisement

If applicable, the following startup messages are displayed immediately after the firmware version is
displayed:
100% and do not switch off the device under any circumstances. After that, the startup process will
continue as usual.
supply with 12V DC is available. There is a separate chapter on this subject in this manual.
Messages warning of a danger are preceded by this display:
Possible warning messages are:
After the firmware version and any startup messages are displayed, the safety timer occurs, which
lasts 15 seconds:
The purpose of the safety timer is that the user can step back from the device before a flame effect
can be initiated.
The safety timer will be started no matter which control method has been selected.
39
If the relative humidity in the device exceeds 30%, you will see this
message. Have the desiccant replaced or carry out the replacement of
the desiccant yourself.
If either a flame quota or a flame duration limit is active, you will see
the displays shown on the left in the LCD one after the other.
After every 50th switch-on of the device, a so-called memory
maintenance is performed to ensure correct functioning of the device
even after many years. Please wait until the progress indicator shows
In this case, the Pump Station battery is probably heavily discharged.
Charge it completely before starting up the system again.
In this case, you can call up the menus and also communicate by
radio. When triggering flame effects, neither ignition sparks are
generated nor magnetic valves are opened, because there is no power
At the same time, you will hear a warning tone if the loudspeaker is
switched on. Immediately after this, the warning indications are
displayed as far as applicable.
There is a risk of unburned fuel being released because the fuel valves
are not closed quickly in the event of an ignition failure.
The tilt switch has been deactivated. There is a risk that the fuel supply
will not be closed if the unit falls over or is tilted.
The 3D tilt sensor system has been deactivated. There is a risk that the
fuel supply will not be closed if the unit falls over or is tilted or its
inclination is changed.
Persons may not be warned of imminent flame effects.
The timer counts down 15 seconds.

Advertisement

Table of Contents
loading

Related Products for GALAXIS SHOWTECHNIK PYROTEC L-Flame Flame Head

This manual is also suitable for:

Pyrotec l-flame pump station

Table of Contents