Cisco 8600 Series Manual page 15

Powering on the Router
Procedure
Step 1
Remove the new or replacement unit from its packaging.
Step 2 Grasp the module with one hand. With your other hand, push in the latch on the module.
Figure 22: Push the Latch on the Module
1
Step 3 Grasp the terminal block with one hand. Place your other hand underneath as you slide the PSU into the bay.
You will hear an audible click sound, which indicates that the module is locked into place, and connected
with the backplane. Only the terminal block housing is not flush with the chassis.
If you do not push the release latch in before you slide the module into the bay, you will not hear the click
sound, but this is an acceptable way of installing the module.
If the module is properly locked in place, you should not be able to remove the module without releasing the
latch.
The following figure shows how a PSU slides into the bay:
Position of the nut on the side of the release
latch before the latch is pushed in
Install a DC Power Supply Unit in the Chassis
2 Position of the nut on the side of the release
latch after the latch is pushed in.
Powering on the Router
15