Related Manuals for ADS ForeSITE FS-UL-4G
Summary of Contents for ADS ForeSITE FS-UL-4G
- Page 1 ADS ForeSITE FS-UL-4G O&M Manual ADS® ForeSITE™ FS-UL-4G Installation, Operation, and Maintenance Manual 340 The Bridge Street, Suite 204 Huntsville, Alabama 35806 (256) 430-3366 www.adsenv.com...
- Page 2 The information contained herein represents the latest information available at the time of publication. ADS LLC reserves the right to make any changes or modifications to the content of this document, without notice, to reflect the latest changes to the equipment. No part of this document...
-
Page 3: Table Of Contents
ADS ForeSITE FS-UL-4G O&M Manual Table of Contents Introduction and Overview ........................4 IMPORTANT NOTICE ..........................5 IMPORTANT WARNINGS ........................5 Lithium Batteries ........................... 5 Hazardous Area Use ..........................6 Safety/Critical Control ........................... 6 Sensitive Area Use ..........................6 Tampering .............................. 6 Opening and Closing the Device ...................... -
Page 4: Introduction And Overview
Expected battery life may exceed five (5) years, depending on device configuration and reporting regime. Remote configuration and device management is supported via ADS® PRISM™ software application, permitting device tuning and upgrades without requiring site visits. The device is housed in a low-profile, robust ABS-plastic enclosure that is UV stabilised and IP68 rated, enabling direct outdoor installation, capable of withstanding brief submersion. -
Page 5: Important Notice
Specifications described are typical only and are subject to normal manufacturing and service tolerances. ADS, LLC reserves the right to modify the equipment, its specification or this manual without prior notice, in the interest of improving product performance, reliability or servicing. -
Page 6: Hazardous Area Use
ADS ForeSITE FS-UL-4G O&M Manual Battery packs must not be exposed to excessive moisture, water, shock, vibration, excessive heat or flame. Battery packs must not be opened or modified in any way. *IF A BATTERY PACK IS DROPPED ONTO A HARD SURFACE IT MUST BE CONSIDERED DAMAGED AND NOT PUT INTO SERVICE UNDER ANY CIRCUMSTANCES. -
Page 7: Regulatory Compliance
ADS ForeSITE FS-UL-4G O&M Manual As this equipment connects to third party cellular networks no responsibility is taken for future changes made by the network providers/network operators that render this equipment unusable or to the reliability of the device connectivity. -
Page 8: Weee Notice (Europe)
For more information about where you can drop off your waste equipment for recycling, please contact ADS Customer Support. -
Page 9: Product Warranty
Conditions available on the website. Likewise, after the new product warranty expires, a product may be returned to ADS for repair, pursuant to the Terms and Conditions. Any repairs or replacements deemed necessary shall be covered as described therein. Device Overview Commented [SC1]: Should we consider showing a “full... -
Page 10: Assembly
ADS ForeSITE FS-UL-4G Manual Assembly Battery Installation NOTE THIS SECTION IS CRITICAL TO ENSURE PROPER OPERATION The internal battery (FS-BAT-001) is field replaceable when required, without the use of special tools. The internal battery is held in place with a black rubber O-ring, which retains the battery against the central mounting plate within the ForeSITE™... -
Page 11: Device Assembly
ADS ForeSITE FS-UL-4G Manual o After installing battery O-ring, ensure battery is connected to the battery input on the PCBA. Device Assembly • The O-ring supplied in the separately labelled bag MUST be installed in the groove of the device lid. -
Page 12: Connecting The Antenna
This grease provides protection for the O-rings and is REQUIRED for system warranty. Connecting the Antenna Connect ADS antenna (9000-0096) to the antenna port, then cover the antenna port and connector using rubber splicing (self-amalgamating) tape to ensure waterproof seal. Configuration Create PRISM™... - Page 13 ADS ForeSITE FS-UL-4G Manual Select “+” by “Monitor” to add a new location Enter location name, monitor series of FS-UL-4G and Serial number from Product label. Enter Latitude/longitude and height from installation site. Enter the installation Date/Time. Select Save/Close.
-
Page 14: Installation
ADS ForeSITE FS-UL-4G Manual Place the magnet over the white dot labelled “TEST” until the “STATUS” light turns green. Remove magnet. Wait for light to start flashing green again before moving to activation validation: • No LED = Device in sleep/standby mode •... - Page 15 ADS ForeSITE FS-UL-4G Manual 1. M5 (0.197 inch) diameter mounting holes with keyslots on one set for simple installations. 2. Top and side mounting options to accommodate 0.375 inch (9.5mm) anchor bolts (included with kit). 3. Side square slots to accommodate band clamps.
- Page 16 ADS ForeSITE FS-UL-4G Manual Ensure mounting is level in the X, Y, and Z axes. Once the mounting bracket is secured to the application structure, insert the device into the bracket by placing the unit housing tabs through the two holes on the bracket. Some flexing of the large tabs on the bracket may be required.
-
Page 17: Installation Notices
ADS ForeSITE FS-UL-4G Manual Installation Notices Installing the unit underground, under the cover of natural or man-made obstructions such as steel reinforced concrete lids, steel manhole covers, or similar will compromise or hinder communications performance, more noticeably in areas with low cellular signal levels above ground. It is always... -
Page 18: Setting Alarms
ADS ForeSITE FS-UL-4G Manual recommended that onsite signal tests be carried out prior to deployment in known low signal areas to determine installation suitability. Proper field installation techniques must be employed to ensure long product life and reliable operation. Equipment must not be installed in locations known to fill with water/wastewater/sea water/other liquids for extended periods of time. -
Page 19: Maintenance And Troubleshooting
ADS ForeSITE FS-UL-4G Manual Maintenance and Troubleshooting The device should be periodically checked to ensure no degradation or cracking of the housing that could introduce water or moisture intrusion. The desiccant packet should be changed during each battery installation. This may be required... -
Page 20: Customer Support
ADS ForeSITE FS-UL-4G Manual Current Draw 50uA sleep, 8mA active, 200mA cell communication, 2A (Peak) cell network detect Environmental IP68 Measurement Range 11.81-196.85 inches (300-5000mm) Measurement Resolution +/- 0.04 inch (+/- 1mm) Measurement Accuracy 1.00% Operating/Storage Temperature Range -4°-149°F (-20°-+65°C)