Table of Contents
Advertisement
STEP 3—ROUTE CABLE THROUGH UPRIGHT AND MAIN FRAME ASSEMBLIES CONTINUED
i.
Using an allen wrench, fully tighten the 2 hex screws on the upper pulleys.
j.
Attach the main frame cable to the cable attachment points on the left and right arm assemblies using the cable bolts.
IMPORTANT! A minimum of 1/2" (12.7 mm) of the threaded portions of the cable bolts must be threaded into the
cable attachment points.
NOTE: Secure the cable bolts to the cable attachment points with the jam nuts.
k. Route the upright cable through the lower pulley assembly and around the lower pulley
l.
Using an allen wrench and a socket wrench or open end wrench, reattach the lower pulley using 1 hex screw, 2 fl at
washers, and 1 lock nut.
m. Attach the upright cable to the main frame cable attachment point using the cable bolt.
IMPORTANT! A minimum of 1/2" (12.7 mm) of the threaded portion of the cable bolt must be threaded into the cable
attachment point.
NOTE: Secure the cable bolt to the cable attachment point with the jam nut.
12
5
3
8
6
12
10
7
9
6
27
Advertisement
Table of Contents
