Page 1
OWNERS MANUAL RB70 GOLF GREENS ROLLER Original Instructions Results through design, not weight. * Roller shown has optional upgrades shown...
Page 2
EU Authorised Representative: VeriSafe Compliance Ltd. 77 Lower Camden St Dublin DO2 XE80 Ireland Original Instructions The products detailed in this manual conform to the following standards: Machinery Directive 2006/42/EC, EMC Directive 2014/30/EU & EN ISO 4254-1:2015 CE Declaration available at www.truturf.com Manual Revision: B Change Description: Manual updated to CE cert level.
Greens Roller and your move to smoother, faster, more consistent putting greens. Distributor Information Name ______________________________ The following operation and maintenance manual has Address ______________________________ been prepared for use with the RB70 Golf Greens ______________________________ Roller. Phone ______________________________ ______________________________ Email ______________________________...
To ensure safe operation of the RB70 Golf Greens • If the trailer catch is not correctly engaged while Roller, please follow the following safety guidelines.
Page 7
Always stop engine before opening safety cover. • Never ride on the machine when machine is being towed. Operator: remember it is your responsibility to be aware of your surroundings. To avoid accidents, think safe and operate safe. RB70 Owner’s Manual...
Page 8
Safety Information IMPORTANT EU MACHINERY DIRECTIVE INFORMATION SAFETY WARNINGS Read Operator’s Manual. Only personnel that have read and fully understood the Operator’s Manual should operate this equipment. Keep Bystanders Away. The operator should ensure that bystanders are not in the immediate vicinity of the machine when it is in use.
Page 9
Safety Information IMPORTANT EU MACHINERY DIRECTIVE INFORMATION SAFETY WARNINGS SOUND AND VIBRATION LEVELS The sound and whole body/hand/arm vibration levels are shown below. Please take note of the levels and determine appropriate operator actions, (wearing hearing protection and/or limiting the time of use when operating the machinery).
Warranty Conditions and Products Covered Tru-Turf Service Department Tru-Turf warrant your Tru-Turf Roller to be free from Tru-Turf Pty Ltd defects in materials or workmanship for two years or 16/6 Energy Circuit, Robina 1550 operational hours*, whichever occurs first. Queensland 4221, This warranty is applicable to all products.
Page 11
• Normal “wear and tear” includes, but is not limited recommended maintenance and/or adjustments. to, damage to seats due to wear or abrasion, worn Failure to properly maintain your Tru-Turf roller per painted surfaces or scratched decals. the Recommended Maintenance listed in the Operator’s Manual can result in claims for warranty...
Page 12
Maintenance is at Owner’s Expense scheduled replacement time for that part. Parts Maintenance of your Tru-Turf roller is to be conducted replaced under this warranty are covered for the as per the owner’s manual for your Tru- Turf product at duration of the original product warranty and the the owner’s expense.
Page 13
Warranty General Conditions Repair by an Authorized Tru-Turf Distributor or Dealer is This warranty gives you specific legal rights, and you your sole remedy under this warranty. may also have other rights which vary from state to state and country to country.
❑ Lightly grease bearings fitted to drive roller, spiker shaft (if fitted) and Smoothing Head pivot bearings. Replace plastic caps if missing. ❑ Oil rod ends, sparingly. ❑ Check tire pressure for proper operating pressure (18-24psi). Do not over inflate. RB70 Owner’s Manual...
This increases the weight onto the rubber drive roller and creates better traction, it also reduces slipping or spinning of the drive roller on the green, depending on the operator’s ability. RB70 Owner’s Manual...
Page 16
Ensure that the hole size in the tow hitch fitted to the towing vehicle is at least 3/8” (10mm) larger in diameter than the pin size fitted on the roller draw bar hitch. RB70 Owner’s Manual...
Page 17
16.There is a park brake fitted to the roller. This is to be used only in an emergency or when parking or leaving the machine, especially on an incline. The park brake should not be used in the normal operation of the roller. RB70 Owner’s Manual...
Page 18
The lift points shown in the diagram, must only be used to lift the machine to carry out transport lifting. It is not permitted to carry out maintenance whilst the roller is hanging from the slings. Sling here (around pivot axle) RB70 Owner’s Manual...
• Do not leave the engine running with the roller parked on the green; the engine vibration will cause roller depression marks on the green. • Move off the green when rolling is complete before putting the trailer in the down position. RB70 Owner’s Manual...
Storing It is important to store this roller in the towing position. This ensures the trailer gas strut is in the closed position, protecting the shaft from the elements which, if damaged, would accelerate seal wear. RB70 Owner’s Manual...
Page 22
If bearing tightness, roughness or excessive looseness is detected, replace the faulty bearings. • If bearings are faulty: a) Remove the complete smoothing head unit assembly from the machine, undo the four RB70 Owner’s Manual...
Page 23
• Only use the manufacturer’s recommended replacement oil filter. When fitting the filter, follow the instructions supplied with the filter. This will ensure that the filter remains tight and that no leaks occur. RB70 Owner’s Manual...
Page 24
If the machine moves, the parking brake requires adjusting. Adjusting Park Brake To adjust the park brake, rotate the knob at the end of the park brake lever in a clockwise direction, when looking down at the lever. RB70 Owner’s Manual...
Replace any decal that is damaged or missing. E8858 DRAWBAR LIFTING RS2413 - Machine ID Plate. (Note: This is not a spare R9086 CHAIN/BELT part and will come attached PINCH POINT from manufacturer). R9870 KEEP BYSTANDERS AWAY R9087 PINCH POINT R6041 COVER IN PLACE RB70 Owner’s Manual...
Rod ends are connected to smoothing roller head and the steering arm. • Rod ends are not broken or seized. • Swivel bearing on connecting the smoothing roller head to the pivot beam, have not seized. • Connecting rods are in place and serviceable. RB70 Owner’s Manual...
Page 54
Accumulated dry debris is not locking the smoothing rollers. Rubber drive roller will not rotate, check: • Roller shaft end bearings have not seized. • Broken chain • Slipping sprockets • The park brake is not locked on RB70 Owner’s Manual...
Need help?
Do you have a question about the RB70 and is the answer not in the manual?
Questions and answers