Advertisement
Unpacking and wall mounting instructions
For the unpacking instructions follow the illustrated steps printed on the
packaging (outside and inside).
For the wall mounting instructions follow the illustrated steps ' to §
printed on the first pages of this instruction booklet.
Make sure that the wall mount is being fixed securely enough so that it meets
safety standards.The weight of the monitor (excl. packaging) is about 43 kg.
Connect your computer
&
Connect one end of the VGA cable 1 supplied to the video card of the
computer and the other end to the
monitor. Fix the connectors firmly with the screws on the plug.
é
In case of a Multimedia computer, connect the audio cable 2 to the audio
outputs of your Multimedia computer and to the
(left) inputs of the monitor.
Daisy chaining
The Active Loop Through facility makes it possible to make a daisy chain with
a second VGA monitor.
"
Connect one end of another VGA cable 3 to the
the rear side of the monitor and the other end to the
second VGA monitor.
'
In case of a Multimedia computer, also connect the audio cables 4 to the
and
outputs of the monitor and to the
AUDIO L
R
of the second VGA monitor.
Note: only use the VGA cables supplied or use cables that are specially delivered
with the monitor.
Connect your Apple Macintosh* computer
Attention: Macintosh computers with separate H and V synchronisation signals
can be used together with a switchable adaptor. Macintosh computers with
Composite Sync and Sync on Green signals may need another special adaptor or
cable. Contact your dealer.
Connect the switchable adaptor for Apple video connectors to one end of a
VGA cable.
Put the DIP switches on the adaptor in the following positions :
1
2
3
off
off
on
Connect the end of the VGA cable with the adaptor to the video card of the
computer and the other end to the
monitor.
Screw the connectors down firmly.
15-pin D sub
(2-row)
*
Apple Macintosh is a registered trademark of Apple Computer, Inc.
connector at the rear side of the
VGA IN
AUDIO IN R
VGA OUT
VGA IN
AUDIO IN L
4
on
connector on the back of the
VGA IN
15-pin mini D sub
(3-row)
(right) and
L
connector at
connector of a
and
inputs
R
1
Advertisement
