9.4 Technical drawing (No. 2832830 / 2832831)
9.5 Installing batteries into transmitter
1. At the rear of the transmitter, unscrew the battery compartment cover.
2. Remove the battery compartment cover.
3. Insert 2x 1.5 V AA batteries into the battery compartment. Slide the fabric battery removal tape under the bottom
battery. Observe the polarity markings in the battery compartment.
4. Replace the battery compartment cover.
à
The transmitter is ready for use
10 Operating the controller
Note:
Receiver and transmitter are paired during production and do not need to be paired before operation.
A
To operate the controller:
1. Supply the receiver with power.
2. Rotate the emergency control button (A) until it pops upwards (disengages).
B
C
D
27