Parts List ITEM PART Size (inch) IMAGE DESCRIPTION QTY. 78.74 x 40.74 Full Frame 4.3 x 1.6 x 2 Rafter Bracket 1.57 x 3.15 x 4.17 FT3 Bracket 4.3 x 4.3 x 1.57 Corner Bracket - CB1 4.33 x 1.57 Joint Flat - JF1 1.57 x 1.57 x 3.94 FT1 BRACKET...
Page 4
Fittings and tools Type Bolt set M10 T25 T38 BTANCM12100 1 1/2" Black M10/12 x 100 mm 1" Tech M10 x 60 Washer Tech Caps screw Concrete Bolt screw Pack A Image NOTE: THE 1 1/2 inch TECH SCREWS ARE FOR FIXING ROOF COMPONENTS ONLY Tools required: Tools included: Drill/Screwdriver...
Page 5
Step 1 Assemble back and side frames S1C as shown below. Using JF1 brackets for the straight joints and CB1 brackets for the corners. Check the dimension of the shelter to ensure correct alignment IMPORTANT: Make sure side frames are aligned as detailed below.
Page 6
Step 2 Attach front S1 frame and ST3 tie bar using CB1 and JF1 brackets.
Page 7
Step 3 Secure the DR1R roof rafters into place using the DR Brackets. The DR1I infill panels are screwed into place using 1" tech screws but must be placed into position at the same time as the end rafters. DR1R Rafter DR1R Rafter DR1R Rafter DR1R Rafter...
Page 8
Step 4 Line up the roof sheets DR2PO/DR2PI as shown below. Install the DRAT2 Angle trims to the bottom of the roof panels and using the 1.5" Tech screws, this will secure the roof sheets. DR2PO DR2PI DR2PO DRATO DRATI DRATI DRATO DRATO...
Page 9
Step 5 Seal the central gaps and edges with the DR1T strips. Once the shelter is in its final position and squared up, attach the FT1 and FT3 foot brackets and use anchor bolts to secure everything to the ground. Finally fit the black plastic caps on exposed nuts and bolts.
Ensure all fittings are tight (for example after a big storm) • Use metal paint to touch up any exposed metal should it get scratched CONTACT DETAILS: No Butts Bin Company, Inc. 16 Birch Lane, Madison, CT 06443 Email : Sales@nobutts.com Web : www.nobutts.com Tel : 1-888-662-8887...