Volkswagen Beetle 1972 Maintenance And Repair Manual page 125

2. Installing Front Fender
a Position fender against car body
and loosely start all bolts
b Place new rubber washer be
tween fender and running board
Install bolt and nul Do not
tighten
C.
Using your hand, press beading
down between fender and body
Make sure the beading is even
around fender
d. Tighten bolts Check that bead¬
ing remains in place while tight¬
ening bolts
e Install grommet for bumper
bracket in fender Install bumper
See Front Bumper, page 112
Connect wires to horn
f. Push gasket for turn signal as
sembly up through fender Posi¬
tion gasket on fender and push
tab on gasket down m hole m
fender Install turn signal assem¬
bly See Front Turn Signal and
Parking Light Assembly, page 95
g Push cable and protective hose
through headlight housing In¬
stall wire terminals in connector
as follows
Top center — yellow wire
Left — white wire
Right — brown wire
h Install headlight assembly Check
headlight setting See Headlight
Assembly, page 92
116