Volkswagen Beetle 1972 Maintenance And Repair Manual page 100

C. Place the retaining ring in place
over the headlight. Turn the ring
until all 3 holes are in line with
the holes in the support nng.
d. Install the 3 screws in the retain¬
ing ring. Tighten the screws
evenly
f. Before installing the trim ring,
make sure the rubber gasket on
the fender is intact.
g. Loosely install the screw m the
trim ring (2 or 3 turns) into the
fender. Position edge of trim ring
over lug on fender Press ring over
lug and tighten screw.
h. Check adjustment of the head¬
light. See Adjusting Headlight,
page 92.
Headlight Assembly
Toots Naadad
Phillips screwdriver. No 1 (magnetic
tip)
Phillips screwdriver. No. 2
1. Removing Headlight
Assembly
a. Remove headlight See Remov¬
ing Headlight, page 90.
b. Using chalk or grease pencil, mark
remaining 3 screw holes on the
support ring and fender housing.
Remove 3 screws and remove
support ring.
SCREW
Mmortals Naadad
Chalk or grease pencil
91