Volkswagen Beetle 1972 Maintenance And Repair Manual page 104

2. Installing Assembly
a Connect wires to bulb holder by
pushing connector on terminals on
holder as follows:
Front bulb — right — brown wire
— center — black wire
— left — gray and
small black wire
Rear bulb —small black wire
from front bulb
b Position holder in gasket Screw
2 nuts and washers on studs un¬
der fender Using 8 mm open end
wrench, tighten nuts.
c. Make sure rubber grommets are
on screws through lens Position
lens and housing on bulb holder
Make sure gasket is positioned
properly Tighten screws Do not
overtighten them
d. Check that bulbs work
Rear Turn Signal. Stop and Tail Light, or
Back-up Light Bulbs
Toots Nmodod Motorists Noodod
Phillips screwdriver. No. 2 See bulb chert, page 89.
95