Table of Contents
Advertisement
Removing and installing hardware
This section provides instructions on how to remove and install hardware for your computer.
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Important safety information" on page 1.
Note: When mounting the computer on a VESA mount, position the computer monitor either horizontally
(with the screen facing forward and the side I/O ports facing right) or vertically (with the screen facing forward
and the side I/O ports facing down).
External options
You can connect external options to your computer, such as external speakers, a printer, or a scanner. For
some external options, you must install additional software in addition to making the physical connection.
When installing an external option, see Chapter 3 "Product overview" on page 29 to identify the required
connector. Then, use the instructions that come with the option to help you make the connection and install
any required software or device drivers.
Computer stand
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
For access, do the following:
1. Turn off the computer and remove all connected devices and cables.
2. Disconnect the computer from ac power and all connected cables.
3. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the computer cover is facing up.
Replacement procedure
Depending on your computer stand, refer to one of the following to replace the computer stand.
• Full-function monitor stand
.
Chapter 6
Hardware removal and installation
51
Advertisement
Table of Contents
