Table of Contents
Advertisement
Available languages
Available languages
GB
Making ice cubes
Fill the ice - cube tray 3/4 full with water and place
it in the freezer. Loosen frozen trays with a spoon
handle or a similar implement; never use sharp-
edged objects such as knives or forks.
Defrosting
A) Fridge compartment
The fridge compartment defrosts automatically.
The defrost water runs to the drain tube via a
collection container at the back of the appliance
(Item 6).
During defrosting, water droplets may form at the
back of the fridge compartment where a
concealed evaporator is located. Some droplets
may remain on the liner and refreeze when
defrosting is completed. Do not use pointed or
sharp-edged objects such as knives or forks to
remove the droplets which have refrozen.
If, at any time, the defrost water does not drain
from the collection channel, check that no food
particles have blocked the drain tube. The drain
tube can be cleared with a pipe-cleaner or similar
implement.
Check that the tube is permanently placed with its
end in the collecting tray on the compressor to
prevent the water spilling on the electric installation
or on the floor (Item 7).
B) Freezer compartment
Defrosting is very straightforward and without
mess, thanks to a special defrost collection basin.
Defrost twice a year or when a frost layer of
around 7 (1/4") mm has formed. To start the
defrosting procedure, switch off the appliance at
the socket outlet and pull out the mains plug.
All food should be wrapped in several layers of
newspaper and stored in a cool place (e.g. fridge
or larder).
Containers of warm water may be placed carefully
in the freezer to speed up the defrosting.
Do not use pointed or sharp-edged objects,
such as knives or forks to remove the frost.
Never use hairdryers, electrical heaters or other
such electrical appliances for defrosting.
Sponge out the defrost water collected in the
bottom of the freezer compartment. After
defrosting, dry the interior thoroughly (Item 8 & 9).
Insert the plug into the wall socket and switch on
the electricity supply.
Replacing the interior light bulb
Should the light fail, switch off at the socket
outlet and pull out the mains plug.
Then ensure the bulb is screwed securely in
the bulb holder. Replace the plug and
switch on.
If the light still fails, obtain a replacement
E14 screw-cap type 15 Watt (Max) bulb
from your local electrical store and then fit it
(Item 10).
Carefully dispose of the burnt-out light bulb
immediately.
Cleaning and care
1. We recommend that you switch off the
appliance at the socket outlet and pull out
the mains plug before cleaning.
2. Never use any sharp instruments or
abrasive substances, soap, household
cleaner, detergent or wax polish for
cleaning.
3. Use luke warm water to clean the
cabinet of the appliance and wipe it dry.
4. Use a damp cloth wrung out in a
solution of one teaspoon of bicarbonate of
soda to one pint of water to clean the
interior and wipe it dry.
5. Make sure that no water enters the
temperature control box.
6. If the appliance is not going to be used
for a long period of time, switch it off,
remove all food, clean it and leave the door
ajar.
7. We recommend that you polish the
metal parts of the product (i.e. door exterior,
cabinet sides) with a silicone wax (car
polish) to protect the high quality paint
finish.
8. Any dust that gathers on the condenser,
which is located at the back of the
appliance, should be removed once a year
with a vacuum cleaner.
9. Check door seals regularly to ensure
they areclean and free from food particles.
10. Never:
• Clean the appliance with unsuitable
material; eg petroleum based products.
• Subject it to high temperatures in any way,
• Scour, rub etc., with abrasive material.
5
Instruction for use
Advertisement
Table of Contents
