Error Codes - Texas A/S RMX 600 User Manual

25. Error codes

Display Notice
E1 Robot outside
the work area
E2 Wheel motor
blocked (locked/
damaged)
E3 Blade engine
blocked
E4 Obstacle sensor
does not work.
E5 The robot has
been lifted
E6 Sensor detected
that the robot
has been tipped
over.
E7 Tilt sensor has
been triggered
Slope may be
too steep
E8 Return to
charging station
failed
Check if the robot is within the work area. If yes:
1. Check if the charging station is properly connected to the power
supply and outlet.
2. Check if the boundary wires are correctly plugged into the
charging station connector (red/black).
1. Turn off the robot completely (hold down the off button) and carry
it to a flat area without obstacles.
2. Turn on the robot, enter PIN code, press START and OK
3. If the error message still appears, turn off the robot. Turn the
robot upside down and check if there is anything preventing the
wheels from spinning.
4. Remove any obstacle that blocks the wheels, turn the robot back
again, turn it on and press START and then OK.
1. Turn off the robot completely (hold down the off button)
2. Turn the robot upside down and check if there is anything that
prevents the blade disc from rotating
3. Remove any obstacle that blocks the blade disc.
4. Move the robot to an area with short grass or adjust the cutting
height to max (60 mm). Turn it on, press START and then OK.
1. The upper cover may not be mounted correctly.
Press it firmly down on the machine (onto the 4 sensor sticks)
2. Turn off the robot and carry it to a flat area without obstacles.
3. Remove the upper cover (see section 20) and check if there are
2 round magnets next to each other on the inside - in front near
the inner edge. If the magnets are missing, the top cover must be
replaced.
4. Turn on the robot, press START and then OK.
1. Turn off the robot and carry it to a flat area without obstacles.
2. Turn on robot, enter PIN code, press START and then OK.
3. If the error message still appears, turn off the robot, turn it upside
down and check if there is anything preventing the front wheel
axle from rotating.
4. Remove any obstacle that blocks the front wheel, turn the robot
over again. Turn it on, enter PIN code and press START and OK
1. Check if slopes are too steep or too wet to drive up, or if the robot
hit something that caused it to tip over. If necessary, this area
should be avoided when moving the boundary cable.
2. Turn the robot over in the correct position, press START and
then OK.
If the slope of the lawn is higher than 20
The area should be removed from the cutting area.
1. Turn off the robot and carry it to a flat area without obstacles.
2. Turn on the robot, enter password, press START and then on OK
1. Check that the boundary wire in front of the charging station is
straight for 1 m without corners or obstacles to ensure correct
connection.
2. The charging station must be placed on a completely flat and
solid surface. It must not be placed on a sloping surface.
3. Avoid that there are more than 2 meters of coiled cable nearby to
the charging station, as this may interfere with the signal. If
necessary, move excess cable and shorten it.
4. Be sure to remove/cut grass that grows up around the charging
station
5. Manually lift the robot into the charging station for charging.
When the robot is fully charged, turn it on, press START, and
then OK.
84
Solution
o
, it can make the robot stop.