Installation And Placement Of Charging Station - Texas A/S RMX 600 User Manual

5. Installation and placement of charging station

Location of the charging station requires that there is a 230V power outlet nearby.
Alternatively, an extension cable must be pulled out to the desired position of the charging
station. The flat entrance of the station shall point to the right.
Make sure there is good Wi-Fi coverage, where you place charging station
(close to the Wi-Fi router)
The charging station can be located in 2 ways:
• Along one of the sides (A)
• In a corner (B)
If a corner is chosen, it must be ensured that the boundary wire can go behind the
charging station as close to the rear plate as possible (<1 cm) and into the connector, see
illustration (B). In this case, there will be a small area behind the charging station, which
cannot be cut. The area may be covered with tiles or stones instead of grass.
Note: It is recommended to have 1-2 m of additional cable in excess, if possible.
See section 7 "Connect boundary wire to charging station".
The charging station must be placed on a completely flat surface and must have a
completely straight stretch of at least 1 meter in front of the charging station, to ensure that
the robot lawn mower gets the right driveway to the charging station. It is important that
this is observed.
51