Techart 096.100.880.009 Mounting Instructions page 4

2. Install TECHART rear spoiler
2.1 Remove lock screws from original rear spoiler profile. Warm in addition the
area up around the screws with a hot-air dryer. Solve with an Allen key (14
mm).
2.2 Put the lock screws into the TECHART rear spoiler with using screw
locking. (if necessary use enclosed washers, if the wing profile should lay
upon the lid)
2.3 Put TECHART rear spoiler on both lifting items.
2.4 Insert the hook spanner (e.g. Porsche tool No. 80/1) or other suitable tool
into the drillings. Turn against the clockwise direction to the lock screws
into the catch of the spoiler intervene. (see fig. 3)
2.5 Rotate the hook spanner around further 90° against the clockwise
direction, until the catch locks.
2.6 Turn the drilling at the external pipe of the lifting item forward.
(against the clockwise direction, fig. 4)
Fig. 3
Fig. 4