OCEM 3 Series Use And Maintenance Manual page 32

LED PAPI 66
Fasten the PCB LED driver (5a) to its supports.
Before connecting the electronic board configure the component for use in the field: with an
appropriate adjustment tool act on the selector (S1) and select the identifier of the LHA unit
on which is intended to install the electronic board.
Reconnect the connectors to the PCBA LED Driver Board, respecting the configuration previously marked.
Position the cover (6a) of the electronic box and tighten the screws.
Reassemble the unit (see the related paragraph in the chapter "ADJUSTMENTS AND MAINTENANCE").
32
UT-MT-0972_1.0_19-09-2022 (EN)
Use and Maintenance Manual