Important Safety Information - Hisense C1 Quick Setup Manual

Important Safety Information

SAFETY WARNINGS
Do not look directly at the lens when this device is on!
• This product comes with a laser module. Do not tear or modify this device in
any manner; otherwise, it may result in personal injury.
RG1 IEC 62471-5: 2015
CLASS 1 LASER PRODUCT IEC 60825-1: 2014
As with any bright light source, DO NOT STARE INTO THE BEAM
λ = 458~472nm/519~531nm/635~651nm
Wavelength 458~472nm/519~531nm/635~651nm
Caution—use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
The Device Complies with 21 CFR 1040.10 and 1040.11 except for confromance as a Risk
Group[0,1 or 2-Select appropriate RG]LIP as defined in IEC 62471-5: Ed.1.0. For more
information see Laser Notice No.57, dated May 8, 2019.
• If this device requires a repair, please wear laser eye protection with an
optical density OD that is 4 or higher and has a wave length of 458-651 nm.
• Do not place any water-containing vessel on this device, such as cosmetics
or liquid medicine.
• If any object or water enters this device, please unplug this device and
contact the service staff of Hisense.
• Do not place any exposed fire source (e.g. burning candle) on this device.
Keep away from high temperature and heat.
• Do not expose the battery to direct sunlight or candle light.
• Keep air vents on both sides clear from any objects to prevent the device
from overheating inside.
• To avoid a short circuit, product damage or electric shock, do not use any
sharp object or metal to touch the ports or other openings on the device.
• If this device has been in a warm environment, allow any built-up
condensation to evaporate first BEFORE you switch the device on.
• Do not allow a child to stand on or climb up this device.
• Do NOT place any object above or in front of the lens because the laser light
could cause the object to become flammable.
• Clean the lens periodically with a clean cloth and make sure the device is
turned off before you start.
3