Power On And Off; Initial Setup - Panasonic PT-50LC13 Operating Instructions Manual

Power ON and OFF
Initial Setup
I
First, check the connection of the Plug to the Wall Outlet and the Antenna/Cable to the RF in Terminal.
(PP. 12-14.)
If using Cable Box, DSS Receiver, or VCR,
• Turn on Cable Box.
• Turn off DSS Receiver, or VCR.
Press the POWER button to turn the
projection display on
(Refer to page 23 for "Turning the Power
ON and OFF".)
Automatic Channel Setting is performed.
Note:
To cancel AUTO SET in progress, press the
SWAP button.
When setup is complete, the lowest
channel picture appears.
If setup is incomplete, the following
screen appears. Check connection of
Antenna/Cable to the RF in Terminal,
then try Automatic Channel Setting
again. (PP. 26-27)
Note:
When the unit is turned on for the firsttime, Automatic Channel Setting is performed.