Installation; Location; Optional External Equipment; Remote Control Battery Installation - Panasonic TH-42PM50U Operating Instructions Manual

Installation

Location

This unit is intended to be used with the stand or bracket. Consult your dealer for available options. Position for
comfortable viewing. Avoid placing where sunlight or other bright light (including refl ections) will fall on the screen.
Use of some types of fl uorescent lighting can reduce remote control transmitter range.
Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or
moisture.

Optional External Equipment

Cables that are not included in the package will need to be obtained separately.
The Video/Audio connection between components can be made with shielded video and audio cables. For best
performance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or
electronic supply store.
Before you purchase any cables, be sure you know what type of output and input connectors your various components
require. Also determine the length of cable you will need.

Remote Control Battery Installation

Requires two AA batteries.
1.Turn the transmitter face down.
Press and slide off the battery
cover.
Helpful Hints:
For frequent remote control users, replace old batteries with Alkaline batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when the remote control acts sporadically or stops operating the Plasma Display.
2.Install the batteries as shown in
the battery compartment.
(Polarity + or – must match the
markings in the compartment.)
Two AA size
3.Replace the cover and slide in
reverse until the lock snaps.
7