Draining Remaining Water And Cleaning The Pump Filter - Beko B3WT5941WS User Manual

propriate brush. If the filters are too dirty,
remove them from their places with a pli-
ers and clean in this way.
c. Take out the filters on the flat ends of the
water intake hoses together with the gas-
kets and clean thoroughly under running
water.
d. Replace the gaskets and filters carefully
and tighten their nuts by hand.
7.5 Draining Remaining Water and
Cleaning the Pump Filter
The filter system in your product prevents
solid items such as buttons, coins and fabric
fibres clogging the pump impeller during
draining of washing water. Thus, the water
will be drained without any problem and the
service life of the pump will extend.
If the product fails to drain water inside it, the
pump filter is clogged. Filter must be cleaned
whenever it is clogged or in every 3 months.
Water must be drained off first to clean the
pump filter.
In addition, prior to transporting the product
(e.g., when moving to another house) water
should be drained completely.
NOTICE:
Foreign substances left in the pump
filter may damage your product or
may cause noise problem.
In regions where freezing is possible,
the tap must be closed, system
hose must be removed and the wa-
ter inside the product must be
drained when the product is not in
use.
After each use, turn off the tap to
which the mains hose is connected.
In order to clean the dirty filter and drain
the water:
a. Unplug the product to cut off the supply
power.
Temperature of the water inside the
product may rise up to 90 ºC. To
avoid the risk of scalding, clean the
filter after the water inside the
product is cooled down.
b. Open the filter cover.
c. Follow the below procedures in order to
drain water.
If the product does not have an emer-
gency water draining hose, in order to
drain the water:
• Place a large container at the end of the
hose to collect the water from the filter.
• When the pump filter starts leaking water
loosen it by turning (opposite clockwise).
Fill the running water to the container you
placed in front of the filter. Keep a cloth
ready to clean the water that may spill.
• Completely turn and remove the pump fil-
ter when the water in the product leaks
out.
a. Clean any residues inside the filter as well
as fibres, if any, around the pump im-
peller region.
b. Replace the filter.
c. If the filter cap is composed of two
pieces, close the filter cap by pressing on
the tab. If it is one piece, seat the tabs in
the lower part into their places first, and
then press the upper part to close.
EN / 38