Using The Remote Control - DeLonghi TCH8093ERBCA Instructions For Use Manual

The appliance comes on with the setting used during
the previous period of operation.
- Press the MODE button (C) to select one of the
following operating modes:
Fan
-
In this mode, only the fan operates and the appliance
does not heat the room.
Freeze prevention
-
In this mode, the appliance keeps the room at a
temperature of 7°C (45°F) to avoid freezing.
Heating 1, 2 and Heating 3
-
In this mode, the desired temperature can be selected
by pressing the adjustment buttons + and – ( B ):
Heating 1
The appliance operates at low power, reducing noise
levels and energy consumption to a minimum.
Heating 2
The appliance operates at medium power.
Heating 3
The appliance operates at high power to heat the room
rapidly.
Please note: Room temperature can be displayed in
either °C or °F. To change the unit of measurement for the
temperature, press the + button for approx. 10 seconds,
then release.
"ECO plus" function
The "ECO plus" function is available in Heating 1, 2 and 3
modes only. To activate the function, press the "ECO plus"
button (D). When this function is active the appliance
automatically sets the most appropriate power level
to guarantee optimum comfort while reducing energy
consumption. While the "ECO plus" function is active, the
appliance may switch automatically to a lower heating
power than the one displayed. This may happen a number
of times in an hour.
Swivel button
To distribute the air flow over a wider surface, press the
swivel button (F) . The appliance swivels to the right
and left. To stop the appliance in the desired position, simply
press the swivel button (F) again.
Turn the appliance off
To turn the appliance off, press the ON/OFF button (A).
The display may show a countdown for about 6 seconds.
Digital 24 h timer (selection from 0.5 hrs to 24 hrs)
This function can be activated from any operating mode.
Auto-start: with the appliance in ON/OFF, press the timer
button (E) . The
the time remaining before the appliance comes on.
To adjust the timer, use the adjustment buttons + and -
(B), then wait a few seconds for the setting to be stored.
The stand-by light (H) is displayed together with the
symbol, indicating that the timer has been set.
When the programmed time is reached, the appliance
comes on with the settings used during the previous period
of operation.
Auto-off: with the appliance on, press the timer button
(E). The symbol is displayed together with the time
remaining before the appliance goes off.
To set the timer, use the adjustment buttons + and - (B),
then wait a few seconds for the setting to be stored. The
current settings are displayed again, together with the
symbol indicating that the timer has been set.
When the programmed time is reached, the appliance goes
off automatically. To go back to operation without the timer,
press the timer button (E) twice. The timer symbol
disappears from the display.

USING THE REMOTE CONTROL

The functions on the remote control are the same as
those on the appliance control panel. For a description of
the functions, see the "Operation and use" section on the
previous page.
Inserting or replacing the batteries
- The remote control is
provided with a lithium
battery CR2032. To let
the appliance function,
remove the battery cover
strip, by pulling it.
- To replace the batteries,
remove the battery cover
by rotating it. Replace the
battery paying attention to
respect the right polarity as shown in figure 1.
- Replace the cover rotating it towards the position
- Old batteries must be removed and disposed off in
accordance with current legislation as they are harmful
to the environment.
WARNINGS:
- This product Contains a button battery. If swallowed, it
could cause severe injury or death in just 2 hours. Seek
15
symbol is displayed together with
Fig. 1
.