Advertisement
then wait a few seconds for the setting to be stored.
The current settings are displayed again, together with the
symbol indicating that the timer has been set.
When the programmed time is reached, the appliance
goes off automatically. To go back to operation without the
timer, press the timer button (E) twice.
The timer symbol
disappears from the display.
USING THE REMOTE CONTROL
The functions on the remote control are the same as those
on the appliance control panel. For a description of the
functions, see the "Operation and use" section on the previ-
ous page.
Installing or replacing the batteries
The remote control is powered
by one CR2032 3V lithium bat-
tery, already included inside.
To operate the remote control,
pull and remove the plastic
strip under the battery cover.
To replace the batteries, re-
move the battery cover by
sliding it as shown in the
figure.
When replacing the batteries, make sure
you respect the polarity (see figure 2).
Replace the cover as shown in the figure. Old batteries are
harmful to the environment and must be removed and
disposed of in compliance with current legislation. Non-
rechargeable batteries are not to be recharged.
WARNING: DO NOT DISPOSE OF BATTERIES IN FIRE. BATTER-
IES MAY EXPLODE OR LEAK.
SAFETY FUNCTIONS
Safety device: the appliance is fitted with a safety
-
device that switches it off in the event of accidental
overheating (e.g. obstruction of air intake and outlet
grilles, motor turning slowly or not at all).
To reset, unplug the appliance from the outlet for a
few minutes, remove the cause of overheating, then
plug in again. If the appliance doesn't work please
contact the De'Longhi Customer Service.
-
Tip-over safety device: a tip-over safety device
turns the appliance off if it falls over or is positioned
inappropriately in such a way as to jeopardize safety.
The appliance emits a beep and a dot flashes on the
display.The appliance resumes operation a few sec-
onds after being placed in an upright position again.
MAINTENANCE
-
Always unplug from the outlet before cleaning.
-
During the season when the appliance is in use, clean
the air intake and outlet grilles regularly using a vacu-
um cleaner.
-
To clean the filter, remove the rear grille by pulling it
outwards (fig. 1). Remove the dust filter that retains
impurities in the air drawn in from the room, blow on
it lightly then put it back in the appliance.
-
Never use abrasive powders or solvents to clean the
appliance.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. lf this equipment does cause harmful
interference to radio or television reception, which can be
Fig. 2
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and
receiver.
-
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Modifications not approved by the party responsible for
compliance could void user's authority to operate the
equipment.
CAN ICES-3 (B) / NMB-3 (B)
14
Advertisement
