Roland MT-32 Owner's Manual page 11

The following two steps are all that is required to set up the
MT-32:
® MASTER VOLUME
Set the overall volume level of the MT-32.
(1) Press the MASTER VOLUME button, (2)
then adjust with the SELECT/VOLUME control.
|
*If the reading on the display remains unchanged when the
SELECT/VOLUME knob is turned, turn the knob counterclock-
wise until the volume number in the display begins to change,
then readjust.
{To prevent any sudden change in output level, the SELECT/
VOLUME control must be turned to the position of output Jevel
as shown in the display before any adjustment can be made.)
"\f the sound is distorted, lower the volume.
@ REVERB MODE
Select the reverb mode as necessary for the master output from the
MT-32.
(1) While holding down the MASTER VOLUME
button and (2) press the VOLUME button, then
(3) turn the SELECT/VOLUME control to adjust
the reverb depth mode.
i a Reverb mode
*The reverb -mode will not effect any part which the Reverb has
been disabled by software.
More functions are available to the user, but they may not pro-
vide noticeable effects if the MT-32 is controlled by software.
The software overrides user-defined settings when there is a
Parameter conflict.