Advertisement
INSTALLATION
•
The cooktop must be set into a worktop at least 20 mm deep.
•
There must be nothing between the cooktop and the oven (cross rails, brackets, etc.).
•
Make sure the power cord is long enough to allow convenient installation.
•
The distance between the lower face of the glass ceramic hob and the cupboard or separating panel
must be at least 20 mm.
•
For built-in dimensions and installation see the picture in this paragraph.
•
A minimum distance must be maintained between the hob and the hood above it. Please refer to the
user manual of the hood for more informations.
•
Apply the supplied gasket to the cooktop (unless it has already been tted), after having cleaned its surface.
•
Do not install the cooktop near a dishwasher or washing machine, so that the electronic circuits do not come into contact with steam or moisture,
which could damage them.
•
If an oven is installed beneath the cooktop, make sure that it is equipped with a cooling system. If the temperature of the electronic circuits exceeds
the maximum permitted temperature, the cooktop will switch o automatically; in this case, wait for a few minutes until the internal temperature of
the electronic circuits reaches a tolerable level, at which point it will be possible to switch the hob on again.
•
ATTENTION: to install the hob on other surfaces than wood (marble, plastic, ceramic, marble, stone, etc.) remember to ask After Sales Service for
the xing plates ( g. 2) Code 4819 404 78697.
PLACING THE HOB
Important: remove any protective lm before installing the hob.
Make sure that the opening in the worktop for the hob is cut according to the dimensions given in the drawing, paying attention to the tolerance range.
The hob should not be forced into the worktop. Forcing the glass-ceramic top may cause it to crack (even at a later date)!
If the worktop is made of wood, use the spring clips and screws provided. Secure the spring clips (A) ( g. 1) with the screws provided (B) ( g. 1) as shown,
paying attention to the speci ed distances. Fit the hob into the worktop.
If the worktop is made of marble, plastic, ceramic, stone, etc., the hob must be secured with special brackets (C) ( g. 2). Fit the hob into the worktop ( g.
1). Place the 4 brackets (C) in position in accordance with the thickness of the worktop as shown in g. 2. Fasten the 4 screws (D) in the positions (E) ( g. 2).
145 ± 1mm
200 mm
DIMENSIONS AND DISTANCES TO BE MAINTAINED
i
Min. 5 cm
A
B
1
L
Min. 40 cm
Min.10 cm
Min.
C
D
C
D
C
E
20 mm
D
2
Min. 50 mm
Min. 6,5 mm
Max. 16 mm
min. 20 mm
Advertisement
