Advertisement
VSA-E06
1. SAFETY INFORMATION
This service
manual
is intended
for qualified service technicians;
it is not meant for the casual
do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been
trained to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely, you
should not risk trying to do so and refer the repair to a qualified service technician.
WARNING
Lead in solder used in this product is listed by the California Health and Welfare agency as a known reproductive toxicant which
may cause birth defects or other reproductive harm (California Health & Safety Code, Section 25249.5).
When servicing or handling circuit boards and other components which contain lead in solder, avoid unprotected skin contact with
the solder. Also, when soldering do not inhale any smoke or fumes produced.
NOTICE
(FOR CANADIAN
MODEL ONLY)
Fuse symbols
-§#—++
(fast operating fuse)
and/or
-§F—*
(slow operating fuse) on PCB indicate that replace-
ment parts must be of identical designation.
REMARQUE
(POUR MODELE CANADIEN SEULEMENT)
Les symboles de fusible
(fusible de type rapide)
et/ou
-§F—*
(fusible de type lent) sur CCI indiquent que
les piéces de remplacement doivent avoir la méme désignation.
(FOR USA MODEL ONLY)
continued
protection of the customer
and service
eechnician: P
OF A POTENTIAL
SHOCK
HAZARD
AND
LEAKAGE CURRENT CHECK
MUST BE CORRECTED BEFORE RETURN-
Measure leakage current to a known earth ground
ING THE APPLIANCE
TO THE CUSTOMER.
(water pipe, conduit, etc.) by connecting a leakage
current
tester
such
as Simpson
Model
229-2
or
2. PRODUCT
SAFETY
NOTICE
special safety characteristics are identified in this
Service Manual.
Electrical components
having such features are
isc alae
identified by marking with a
/4\ on the schematics and
Leakage | o5ma
on the parts list in this Service Manual.
pans
lel
The use of a substitute replacement component which
under
dose not have the same safety characteristics as the
PIONEER recommended replacement one, shown in the
parts list in this Service Manual, may create shock, fire,
or other hazards.
Product Safety is continuously under review and new
instructions are issued from time to time. For the latest
information,
always
consult
the current
PIONEER
Service Manual. A subscription to, or
additional copies
iene ant
es
of, PIONEER Service Manual may be obtained at a
plug as required)
=
ground
nominal charge from PIONEER.
AC Leakage Test
Test all
exposed metal
surfaces
Also test with
Advertisement
