Magikitch'n MKG 24 Installation And Operation Instruction Manual
Gas griddle
Hide thumbs
Also See for MKG 24:
- Technical & service manual (26 pages) ,
- Installation & operation manual (24 pages) ,
- Installation and operation instructions manual (25 pages)
Table of Contents
Related Manuals for Magikitch'n MKG 24
Summary of Contents for Magikitch'n MKG 24
- Page 1 MKG 24, 36, 48, 60, 72 GAS GRIDDLE INSTALLATION – OPERATION INSTRUCTIONS MAGIKITCH’N P.O. BOX 501 CONCORD NH 03302-0501 509 ROUTE 3A BOW NH 03304 800-258-3708 603-225-6684 FAX 603-225-8497 www.magikitchn.com L25-012 Rev 2 (06/03)
- Page 2 THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE FOR YOUR SAFETY DO NOT store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. WARNING Improper installation, alteration, service or maintenance can cause property damage, injury or death.
- Page 3 WARNING Do not attempt to move this appliance when the unit is at operating temperature. Serious personal injury could result if skin comes in contact with the hot surfaces. CHECKING YOUR NEW GRIDDLE Your new griddle has been carefully packed into one crate. Every effort has been made to ensure that you new griddle is delivered to you in perfect condition.
- Page 4 FUEL SUPPLY LINE LEAK AND PRESSURE TESTING The fuel supply system must be tested before the appliance is used. If the fuel line is going to be tested at a pressure greater than ½ PSIG (3.45 kPA), make sure that the appliance is disconnected from fuel line. If the fuel line is to be tested at a pressure equal to or less than ½...
- Page 5 NOTICE When this appliance is installed with casters, it must be installed with the casters supplied. A connector complying with ANSI Z21.69-CGA-6.16 and a quick disconnect device complying with ANSIZ21.41/CAN 1-6.9. It must also be installed with restraining means to guard against transmission of strain to the connector, as specified in the appliance manufacturer’s instructions.
- Page 6 CAUTION If pilot(s) extinguish or gas supply is interrupted, turn thermostat knobs and the gas shut off valve to the “OFF” position and wait 5 minutes before attempting to relight. SHUTTING DOWN, (Standard Gas Thermostat): Turn thermostat knobs to the “OFF” position. Turn gas shut off valve to “OFF”...
- Page 7 CLEANING , MAINTENANCE AND SERVICING OUTER SIDES AND FRONT - The outer sides and front are stainless steel. Any reputable cleaner can be used to clean these surfaces. GREASE TUB – The grease tub is designed to contain grease run off from the griddle surface. The grease tub should never be allowed to overfill, and should be emptied daily and the grease disposed of properly.
Need help?
Do you have a question about the MKG 24 and is the answer not in the manual?
Questions and answers