Adjustments After Replacing The Bal Board Or Lcd Panel; Updating The Software; Selecting The Model - Sony KDL-32EX40B Service Manual

2-2. ADJUSTMENTS AFTER REPLACING THE BAL BOARD
OR LCD PANEL
The following procedures must be completed after replacing the BAL
Board or the LCD panel.

Update the TV to the latest software version

Select the Model

Select the Destination

Verify model and panel information are correct

Reconnect all cables

2-2-1. UPDATING THE SOFTWARE

After replacing the BAL Board or the LCD Panel, you must update the
software to the latest version.
Before you begin

Disconnect all cables (RF, External input, Ethernet, etc.)
from the TV
Instructions for updating the software are included with the software
package. After completing the software update, proceed to "Selecting
the Model".
KDL-32EX40B/40EX40B
SERVICE ADJUSTMENTS

2-2-2. SELECTING THE MODEL

After replacing the BAL Board or LCD Panel, go into Service Mode to set
the Model data value.
1. TV must be in standby mode. (Power off).
2. Access Service Mode.
Press the following buttons on the Remote Commander
within a second of each other:
DISPLAY
Channel
3. Display the DIGITAL Service Menu.
NOTE: There are 3 Service Menus for this model, DIGITAL,
CHASSIS, and SUB. If the DIGITAL Service Menu is
not displayed, press JUMP or OPTIONS on the Remote
Commander.
DIGITAL
001 OP
000 VERS
<MAIN>
DM1.301J00AA
M2.105C
DD1.016J00AA
(DM1. 3 01J00AA)
WP00.521J00AA
ID1C117081
PID04020000
WF:2.0.0.99
WF:0B
Camera FW
Camera FW
4. Press to move to the 002 MODEL (Next) category.
2
5 + POWER
Volume
SERVICE
---
<SUB>
SM1.010W00AA
SB1.000W00AA
SD1.010W00AA
RF01.05
ID1C117081
LTY320AB01
<BEM>
BM1.012W00LU
BB1.000W00LU
BD1.011J46LUX
---.---------
22