Problems And Solution; Guarantee And Service - Hisense Hi Move III Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 27
matches, liquids (e.g. water, carpet cleaning foam), or sharp or pointed objects (broken glass
etc.). // Keep the suction tube or the open part of the appliance away from your face and body.
// Never use the appliance to vacuum construction material (such as fine sand, lime, cement
powder, toner dust etc.). This can cause damage to the appliance.

Problems and solution

Problem
Not working.
Suction power has
decreased.
The VC is not
charging.
Use very short time after
charging.
Environment
Do not throw away the appliance with the normal household waste at the end of its life. Hand it in at an official
collection point for recycling. By doing this, you help to preserve the environment.
This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and
This guideline is the frame of a European-wide validity of return and recycling on Waste Electrical and
Guarantee & service
If you need information or if you have a problem, please contact the Hisense Customer Care Centre in your
country (the phone number is in the worldwide guarantee leaflet). If there is no Customer Care Centre in your
country, go to your local Hisense dealer or contact the Service department of Hisense domestic appliances.
Note: The warranty on the battery of vacuum cleaner is 12 months.
For personal use only!
Possible reason
The battery is dead.
The handy VC is not assembled
correctly.
The dust cup is full.
Block in filter.
Block in the air inlet tunnel or
on the roller of electrical brush.
The charger is not connected on
socket.
The connector of charger is not
connected to the hole of base body.
The handy VC is not assembled
to the body.
Not enough charging time.
The battery is aging.
Electronic Equipment (WEEE).
Electronic Equipment.
28
Solution
Charge.
Assemble the handy VC
correctly.
Pour out the dust.
Clean or change filter.
Clean the electrical
brush.
Connect the charger on socket.
Connect the charger with
base body of VC.
Assemble the handy VC
on body.
Charge according to instruction.
Change the battery.

Advertisement

Table of Contents
loading

Table of Contents