Getting Started; Master Power Switch; Battery Recharging - VTech KidiZoom Smart Watch MAX Instruction Manual

WARNING
Prolonged wearing of any watch can cause skin irritation for some people.
Clean the watch band regularly by wiping it with a damp cloth. Be careful
not to get the watch wet, as this could damage the unit. Do not use soaps
or household cleaners, as they can get trapped under the band and irritate
the skin. Always dry the band before putting it back on. Irritation can also
occur if the band is too tight or too loose. If redness, swelling, itchiness, or
any other irritation occurs, remove the watch and consult a doctor.

GETTING STARTED

MASTER POWER SWITCH

When you use KidiZoom
for the first time, slide the Master Power Switch
(located on the underside of the watch) to the On
position, using a small tool such as a paper clip if
necessary. Fully charge the watch before first use.
A full charge will take about three and a half hours.
When the Master Power Switch is set to the Off
position, the unit will not function, and the battery
will not charge. Only move the switch to the Off
position if the watch will not be in use for an extended period of time.
Note: It is not necessary to switch off the watch in daily use. Once the
Master Power Switch is Off, the watch will stop functioning. After it is
turned on again, the time and date will have to be reset.

BATTERY RECHARGING

Note: Adult operation required.
The watch should be fully charged before first use. To charge the
KidiZoom ® Smart Watch MAX, connect the watch to a computer with the
included Micro-USB Cable. To do so correctly, please follow these steps:
Make sure that the Master Power Switch is set
•
to the On position before charging.
Pull up the rubber cover of the Micro-USB Port
•
on the side of the watch.
Insert the included Micro-USB Cable (small end)
•
into the Micro-USB Port on the watch.
6
® Smart Watch MAX