Getting Started; Battery Removal And Installation - VTech Spin Master Nickelodeon Paw Patrol Learning Pup Watch Instruction Manual

de votre enfant ne soit ni trop serré, ni trop lâche. Si vous observez
des rougeurs, gonflements ou autre irritation, veuillez consulter un
médecin avant de remettre la montre.

GETTING STARTED

Battery Removal and Installation

NOTE: For best performance, remove the
factory-installed battery from the Learning Pup
Watch and use a new battery.
1. Make sure the watch cover is closed.
2. Find the battery cover located on the back
of the unit, use a screwdriver to loosen the
screw and then open the battery cover.
3. Use the screwdriver to push the metal piece
according to the diagram. Remove the battery
when one end of the battery pops up.
4. Follow the diagram inside the battery box to
install one new CR2450 battery, press it into
the battery room.
5. Replace the battery cover and tighten the
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
5 5
5