Pioneer VSX-9700S Operating Instructions Manual page 21

REAR PANEL FACILITIES
@ @® @OO®D ®
® ®
@ FM/AM ANTENNA terminals
Use these antenna terminals for reception of normal FM and AM
broadcasts.
Attach the accessory AM Loop and FM T-type antennas, here.
© For details regarding antenna connection, see the section ''Hints for
Better Reception'' on page 44.
@) GND terminal
Connect the turntable ground lead to this terminal.
@) CONTROL IN, OUT jacks
Used for system control with other Pioneer components bearing the
mark.
Leper For connection from the CONTROL OUT jack of another
component.
OUT ...... eee For connection to the CONTROL IN jack of another
component.
NOTE:
The receiver's remote sensor does not function when a plug is inserted
in the IN jack. To operate, point the remote control unit at the remote
sensor on the component to which the receiver's IN jack is connected.
CONTROL,
To the CONTROL
IN jack of the Pioneer
component bearing
the SRI mark.
Pioneer component
bearing the mark.
Receiver
Remote control unit
© ®OO ®© ®®M @
* Illustrations show U.S. models.
® ®
@ ® ®
@) MULTI-FROOM REMOTE IN jack.
When using the optional MR-100 adaptor for multi-room remote control,
connect to this jack.
©) REAR AMP jacks
[PRE OUT]
When a separate power amplifier is used to drive the rear speakers,
connect the power amplifier to these jacks.
[POWER IN]
When a separate pre-amplifier is used for rear speakers and this unit
is used as a power amplifier, connect the pre-amplifier to these jacks.
© CENTER AMP jacks
[POWER IN]
When a separate pre-amplifier is used for center speaker and this unit
is used as a power amplifier, connect the pre-amplifier to this jack.
[PRE-OUT]
When a separate power amplifier is used to drive the center speaker,
connect the power amplifier to this jack.
@ CENTER SPEAKER terminal
Connect the center speaker here.
NOTE:
© Use a center speaker with an impedance from 8 ohms to 76 ohms.
° Do not allow any of the cord's conductors to protrude from the
terminals or touch any other conductors. Malfunctioning or
breakdown may occur when conductors come into contact with each
other.
VIDEO ADAPTOR jacks
Use to connect a video adaptor component such as a video enhancer
or color corrector.
@)S (connector) video jacks
When used in conjunction with a VCR, Video disc player (CDV player)
or monitor TV equipped with S video jacks, connect to these jacks .
21
<ARB1234>