JVC LX-D700U Instruction Manual page 2

Z (600¥ed ON)
Thank you for purchasing this projector. Before using it, read and follow all instructions care-
fully to take full advantage of the projector's capabilities.
SAFETY PRECAUTIONS
IMPORTANT INFORMATION
WARNING:
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT
EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
WARNING:
THIS APPARATUS MUST BE EARTHED.
CAUTION:
To reduce the risk of electric shock, do not remove
cover.
Refer servicing to qualified service personnel.
MACHINE NOISE INFORMATION
(Germany only)
ChangesMachine Noise Information Ordinance 3.
GSGYV, January 18, 1991: The sound pressure level at
the operator position is equal or less than 70 dB (A)
according to ISO 7779.
FCC INFORMATION (U.S.A. only)
CAUTION: Changes or modification not approved could
void the user's authority to operate the equipment. a Perey
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. However,
there is no quarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.
~ Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
~ Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Nicht the dealer or an experienced radio/TV technician for
ip.
Declaration of conformity
Modet Number: LX-D700U
Trade Name: Jvc
Responsible party: PSEL Dept. U.S. JVC Corp.
Address: 41 Slater Drive,
Elmwood Park, N.J. 07407
Telephon Number: (201)794-3900
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may Rot, cause harmful interference, and (2) this
serio erat can 3
KSRENSNES TOCENEY, KRTUUINTY MET Srence
thn CAUSE IESIRN Operation,
@
IMPORTANT SAFEGUARDS
Electrical energy can perform many useful functions. This
unit has been engineered and manufactured to assure
your personal safety. But IMPROPER USE CAN
RESULT IN POTENTIAL ELECTRICAL SHOCK OR
FIRE HAZARD. In order not to defeat the safeguards
incorporated into this product, observe the following
basic rules for its installation, use and service. Please
read these "important Safeguards' carefully before use.
— All the safety and operating instructions should be
read before the product is operated.
- The safety and operating instructions should be
retained for future reference.
— All warnings on the product and in the operating
instructions should be adhered to.
— All operating instructions should be followed.
— Unplug this product from the wall outlet before clean-
ing. Do not use liquid cleaners or aerosol cleaners.
Use a damp cloth for cleaning.
— Do not use attachments not recommended by the
product manufacturer as they may be hazardous.
— Do not use this product near water. Do not use imme-
diately after moving from a low temperature to high
temperature, as this causes condensation, which may
result in fire, electric shock, or other hazards.
— Do not piace this product on an unstable cart, stand,
or table. The product may fall, causing serious injury to
a child or adult, and serious damage to the product.
The product should be mounted according to the man-
ufacturer's instructions, and should use a mount rec-
ommended by the manufacturer.
— When the product is used on a cart, care
should be taken to avoid quick stops,
excessive force, and uneven surfaces
which may cause the product and cart to
overturn, damaging equipment or causing
possible injury to the operator.
- Slots and openings in the cabinet are provided for ven-
tilation. These ensure reliable operation of the product
and protect it from overheating. These openings must
not be blocked or covered. (The openings should
never be blocked by placing the product on bed, sofa,
rug, or similar surface. It should not be placed in a
built-in installation such as a bookcase or rack unless
proper ventilation is provided and the manufacturer's
instructions have been adhered to.)
For proper ventilation, separate the product from other
equipment, which may prevent ventilation and keep
distance more.than 10 cm.
— This product should be operated only with the type of
power source indicated on the label. If you are not
sure of the type of power supply to your home, con-
sult your product dealer or local power company.
This product is equipped with a three-wire piug. This
plug will fit only into a grounded power outlet. If you
are unable to insert the plug into the outlet, contact
your electrician to install the proper outlet. Do not
defeat the safety purpose of the grounded piug.
Power-supply cords should be routed so that they
are not likely to be walked on or pinched by items
placed upon or against them. Pay particular attention
to cords at doors, plugs, receptacles, and the point
where they exit from the product.
For added protection of this product during a light-
ning storm, or when it is left unattended and unused
for long periods of time, unplug it from the wall outlet
and disconnect the cable system. This will prevent
damage to the product due to lightning and power
jine surges.
Do not overload wail outlets, extension cords, or con-
venience receptacles on other equipment as this can
result in a risk of fire or electric shock.
Never push objects of any kind into this product
through openings as they may touch dangerous volt-
age points or short out parts that could result in a fire
or electric shock. Never spill liquid of any kind on the
product.
Do not attempt to service this product yourself as
opening or removing covers may expose you to dan-
gerous voltages and other hazards. Refer all service
to qualified service personnel.
Unplug this product from the wall outlet and refer ser-
vice to qualified service personne! under the follow-
ing conditions:
a) When the power supply cord or plug is damaged.
b) If liquid has been spilled, or objects have fallen on
the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by fol-
lowing the operating instructions. Adjust only
those controts that are covered by the Operation
Manual, as an improper adjustment of controls
may result in damage and will often require exten-
sive work by a qualified technician to restore the
Product to normal operation.
e) If the product has been dropped or damaged in
any way.
f) When the product exhibits a distinct change in per-
formance—this indicates a need for service.
When replacement parts are required, be sure the
service technician has used replacement parts spec-
ified by the manufacturer or with same characteris-
tics as the original part. Unauthorized substitutions
may result in fire, electric shock, or other hazards.
mae] ot
3
— Upon completion of any service or repairs to this
product, ask the service technician to perform safety
checks to determine that the product is in proper
operating condition.
The product should be placed more than one foot
away from heat sources such as radiators, heat reg-
isters, stoves, and other products {including ampli-
fiers) that produce heat.
When connecting other products such as VCR's, and
personal computers, you should turn off the power of
this product for protection against electric shock.
Do not place combustibles behind the cooling fan.
For example, cloth, paper, matches, aerosol cans or
gas lighters that present special hazards when over
heated.
Do not look into the projection lens while the ilumi-
nation lamp is turned on. Exposure of your eyes to
the strong light can result in impaired eyesight.
Do not look into the inside of this unit through vents
(ventilation holes), etc. Do not look at the illumination
lamp directly by opening the cabinet while the illumi-
nation jamp is turned on. The illumination lamp also
contains ultraviolet rays and the light is so powerful
that your eyesight can be impaired.
Use only the accessory cord designed for this prod-
uct to prevent shock.
The power supply voltage rating of this product is AC
200-240V, the power cord attached conforms to the
following power supply voltage. Use only the power
cord designated by our dealer to ensure Safety and
EMC.
When it is used by other power supply voltage,
power cable must be changed.
Consult your product dealer.
Power cord
LX-D700E/EK
Power supply voltage: AC 200-240V
LX-D700U
Power supply voltage: AC 100-120V
3/3/N002 |