JVC GR-D93 Instructions Manual page 47

CAUTIONSEN
47
About moisture condensation
• You have observed that pouring a cold liquid into a glass
will cause drops of water to form on the glass' outer
surface. This same phenomenon occurs on the head
drum of a camcorder when it is moved from a COOlplace
to a warm place, after heating a cold room, under
extremeIy humid conditions or in a place directly
subjected to the cool air from an air conditione_
• Moisture on the head drum can cause severe damage to
the video tape, and can led to internal damage to the
camcorder itse}f.
Serious malfunctionin_l
I If_a_ fu;t(tilyni_g c°CCUru_t ; t°°uPr lu2nlgjIh_ _taler I
The camcorder is a microcomputer-control}eq device.
Externa} noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such
cases, first disconnect its power supply unit (battery
I pack, AC Adapter, etc.) and wait a few minutes and
then re-connect it and proceed as usual from the
I beginning.
Declaration of Conformity
Model Number GR-D93U/D73U/D33U
Trade Name JVC
Responsible party JVC AMERICAS CORR
Address 1700 Valley Road Wayne,
N. J. 07470
Telephone Number 973-317-5000
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
inc{udinginterference that may cause undesired
operation.
Change or modifications not approved by the party
responsible for compliance could void the user's
authority to operate the equipment. This equipment
has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the
FCC Rules. These _imits are designed to provide
reasonable protection against harmfu_ interference in a
residential installation.This equipment generates,
uses, and can radiate radio frequency energy and, if
not installedand used in accordance with the
instructions,may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmfu{ interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help.
This Class B digital apparatus complies with Canadian
ICES-003+
Cet appareil numerique de la classe Best conforme &
la norme NM8-003 du Canada.