Table of Contents
Advertisement
Chapter 1: Preparing the Emulator
Step 3. Install Boards into the HP 64700 Card Cage
13 This step applies only to the HP 64700A. The HP 64700 has a built-in LAN interface.
Before you install the LAN card, you must remove the rear panel cover plate that is replaced by the
bracket shown in the figure below.
To install the LAN card, position the BNC and 15-pin connectors of the LAN card through the openings
in the rear panel, press the card into the mother board socket, secure the card with the two Torx T-10
screws, and mount the bracket to the rear panel with the four Torx T-10 screws.
14 This step applies only to the HP 64700A. If you wish to install the flash card (used for updating
firmware, see chapter 5), refer to the diagram above. Install the flash card in any available slot between
the 80-channel analyzer card and the HP 64748C control card in the cardcage. Insert the flash card in the
plastic guides. Make sure the connectors are properly aligned. Then press the card into the mother board
sockets. Make sure the card is seated all the way into the sockets.
21
Advertisement
Table of Contents
