Table of Contents
Advertisement
Chapter 6: Solving Problems
To verify the performance of the emulator
Examples
If you are using a LAN, you can use the telnet capability with the Terminal
Interface:
Note: the HP 64700 telnet capability is not supported by Hewlett-Packard.
After about a minute, the emulator should display a list of tests which were
performed, and whether they were passed or failed.
If you have an emulation failure, you can replace the assembly that failed through
your local Hewlett-Packard representative, and through the Support Materials
Organization (SMO). Refer to the list of replacable parts in chapter 7.
When your performance verification test is complete, use the keyboard <CTRL>d
keys to end the emulation session.
To verify installation of memory modules in the deep analyzer card or in the
emulation probe, type the ver command as follows:
M>ver
The emulator should display a message similar to the following:
Copyright (c) Hewlett-Packard Co. 1987
All Rights Reserved.
written permission is prohibited, except as allowed under copyright laws.
HP64700 Series Emulation System
Version:
A.04.00 22Oct92
HP64782C Motorola 68332 Emulator
Version:
A.00.00 01Jun94
Control:
HP64748C
Speed:
25.1 MHz
Memory:
256 Kbytes
Bank 0:
HP64171A (35ns) or HP64172A (20ns) 256 Kbyte Memory Module
HP64740 Emulation Analyzer
Version:
A.02.02 13Mar91
HP64701A LAN Interface
Version:
A.00.04 21Oct91
104
1 From your host computer enter the command: telnet <emulator_name>.
2 Now enter the command: pv 1
Reproduction, adaptation, or translation without prior
Emulation Control Board
Advertisement
Table of Contents
