Table of Contents
Advertisement
M3628UCT
DC O
4.3.2.
Four PowerPole connectors provide the user with DC output voltage between
0 and 20VDC, a charge/discharge path for the current to and from the
capacitor being tested, and precision Kelvin measurements for ESR. The
standard cables shipped with the system include either two high-current
alligator clips or ring terminals, and two measurement clip leads.
D
4.3.3.
The digital display presents the user with information about the present status
of the system, including the output voltage and current. The display also
presents the user with options to control system operation, including charging
and discharging attached capacitors.
I
4.3.4.
NDICATOR
There are three LEDs below the Display to indicate the operational status of
the unit.
•
•
•
D
4.3.5.
Each of the four buttons corresponds to a direction, up, down, left or right.
Up and down move the cursor among menu items. On screens where
numbers are input by the user, the left and right buttons move the cursor,
while the up and down buttons change the selected digits. On some screens,
certain buttons may have no function at all.
E
4.3.6.
V
4.3.7.
DANGER!
P
4.3.8.
The Power Switch also acts as a circuit breaker to protect from overload
conditions. If the breaker is tripped, you can reset it by simply turning the
switch back on.
16
M
UTPUT AND
EASUREMENT
ISPLAY
LED
S
Green: Unit is powered on.
Yellow: Unit is active.
Red: A fault has occurred. Check display for description.
B
IRECTIONAL
UTTONS
C
NTER AND
ANCEL
The green enter button selects menu options. On most screens, the
cancel button will return you to the previous screen. While the system is
active, the cancel button will halt the operation and return to an idle state.
P
OLTAGE
RESENT
Do not use this light as an indication that the output is safe to work on!
Always check the output with a working voltmeter before servicing
equipment, as the lamp may be malfunctioning!
ELECTROCUTION HAZARD! This unit produces potentially dangerous
voltages from low impedance sources that can cause injury or death.
Always follow safety protocols when working with energized equipment
and charged capacitors!
A red light indicates that there is voltage on the DC output of the unit. Do
not touch the output connectors or the attached equipment while this light
is on, as electric shock could result.
S
/ C
OWER
WITCH
IRCUIT
C
ONNECTORS
B
UTTON
I
NDICATOR
B
REAKER
Advertisement
Table of Contents
