Advertisement
1 resistance
test to
abinet part, such as
read between 3MQ2Q
<imately infinity to
lulpment should be
innel
| controls
rding mode selector
EQ, EE straight)
irce)
{_ selector
For [XA] , [PA] and[PE] areas
AC outlet (Unswitched)
For [M] ,[MC] ,[XA] ,[PA] and
[PE] areas
Line output
Rec out
Mi OPERATION
ey Input selectors: Select the sound source.
4) Loudness switch: "off"
m@ '"AV/aux": To use equipment connected to the
auxiliary input (''AV/AUX'') terminals.
5) Tape-monitor selector:
''tape 1/DA tape" (Refer to note).
g@ "CD":
To listen to a compact disc.
(The ''tape"' Indicator will be illuminated)
@ ''tuner'
To listen to radio broadcasts.
@ "phono":
Tolisten to phono discs.
@ Balance control: 'center position"
ye CD direct switch:
"'off''
© Tone controls: ''center position":
To listen to CD direct: "on"
Integrated
amplifier
(option)
® Begin the disc play or tune to the radio
broadcast.
7) Adjust volume level.
fe)
"on"
(Bm)
iE) Adjust tone quality as desired.
This unit
(SH-8028)
To listen to corrected sound of phono discs or radio.
12
Set to any position.
To record corrected sound of phono discs or from radio.
"EQ" (Bm)
To record the uncorrected sound of phono discs or from the radio.
} "straight" (mm)
To listen to corrected sound from a tape deck.
"tape" (H_. m)
| Set to any position.
Press the equalization switch (equalizer) in to the ''off'' (= — BM) position to listen to uncorrected sound, or when recording.
Notes
e ifthe amplifier has a recording mode selector and an input selector: (Make setting as shown in the figure. )
Jer
selector)
| i '
-
phono or tuner
U
|
o
OO
gg 000
0
O
e
If your amplifier has terminals (GRAPHIC EQ./EXTERNAL) for connection of other equipment, use of the recording selector is
unnecessary.
(input selector)
mee es
SH-8028
How to remove the band level
control volume P.C.B.
Mi DISASSEMBLY
INSTRUCTIONS
Ref. No.
How to remove the cabinet
@ Push the 3 tabs aside. (@)~ ©) )
@ Remove the sub panel.
@ Remove the 14 knobs.
Tab (C)
How to remove the front panel
Procedure
gaa
@ Remove the 2 screws (@, @)
@ The tabs with project (at 3partions)
from the front panel are engaged with
the bottom board.
@ Push the 11 tabs aside. (Q@~ @)
@ Remove the band level control volume
PG, 6,
Front panel
OS
eee
ogee',
)
es
Sty
Band level
volume P.C.B.
@® Remove the 2 connectors (J1, J2) of front panel.
J1 (4pin)
@ How to fit the volume rod
Front panel
Volume shaft
a
Light guide plate
LED
How to remove the power supply
P.C.B. and switch P.C.B.
@ Remove the 3 screws (Q@~ @) of
power supply P.C.B.
@ Remove the 4 screws (@) ~ @) of
switch P.C.B.
Procedure
1 +2 »3
ii
Insert with long leg (anode) down.
Fit the knob with gate hole side down.
Advertisement
