Philips 32PF9968 User Manual page 48

EN
Software Upgrade Application
Upgrade busy...
Software Id: TL32E-234
Loading
Validating
Programming
48
Annex 2 (Continued)
Automatic software upgrade procedure
1. Switch off your TV and remove all memory devices.
2. Insert the USB portable memory that contains the
downloaded software upgrade.
3. Switch on your TV with the power key B at the side of the
TV.
4. At startup the TV will scan the USB portable memory until
it finds the update content.The TV will automatically go to
Done
the upgrade mode. After a few seconds it will display the
Done
status of the upgrade procedure.
Warning:
- you are not allowed to remove the USB portable
memory during the software upgrade procedure;
- in case of a power drop during the upgrade procedure,
don't remove the USB portable memory from the TV.
The TV will continue the upgrade as soon as the power
comes back;
- if you try to upgrade to a software version lower than
the current version, a confirmation will be asked.
Downgrading to older software should only be done in
case of real necessity;
- if an error occurs during the upgrade you should retry
the procedure or contact your dealer;
- the automatic software upgrade procedure will only start
if the version on the USB portable memory is different
from the one in the TV.
5. When the software upgrade was successful, remove the USB
portable memory and restart your TV with the power
switch B at the side of the TV.
Your TV will start up with the new software.
Note: once the upgrade is finished use your PC to
remove the TV software from your USB portable memory.