Table of Contents
Advertisement
PARTS IDENTIFICATION
CCP-13B CASSETTE TO CASSETTE PRINTER
@ ORIGINAL cassette compartment
@ COPY cassette compartments
© EJECT buttons
Depress to eject a cassette.
@ Track selectors
Select one or both sides of the original cassette
in one run of
duplicating.
2CH:
for one side duplication. At each end-of-tape, the tapes will
stop automatically.
4CH:
for both
sides duplication.
At the end-of-tape
of original
cassette, the tapes will be rewound automatically, and at each
beginning-of-tape the tapes will stop automatically.
The left-most selector for the original cassette also controls the
automatic tape rewind and stop systems. See page 9.
@ POWER switch and pilot lamp
Turn the switch ON and the lamp will light.
@ Allow a few seconds of build-up time before operating the unit.
@ RECORD indicators
:
In the duplicating mode, when the recording bias current is applied
to the recording heads, the indicators illuminate.
When the original tape is set in the rewind mode at the end-of-tape
in both sides duplication, the indicators will go off.
At each tape-end-stop in one side duplication, the indicators wiil
stay on showing that the printer is in standby for duplicating the
other
side or the next duplicating. To turn off the indicators,
depress the STOP button.
@ LEVEL CONTROL knobs and meters
These knobs control the output level of each track of the original
tape; turn to the right to increase the level, to the left to decrease it.
The
level is shown
on the respective
meters.
Adjust the levels
before
starting
duplication
as
described
in "LEVEL
ADJUST-
MENTS" on page 7.
@ When
the CCP-13B
is connected
to the ORM-10,
the meter
deflections show the jevel of the open reel master tape.
@ REWIND button
@ When no cassette is inserted in a compartment, the rewind func-
tion of that compartment is inoperative.
@ When an additional cassette printer is connected,
set the left-
most track selectors on both printers to 4CH so that the tapes of
the additional cassette printer can be rewound simultaneously.
© STOP button
Depress to stop the tapes.
Also controls the stop function of all additional printers connected.
@ RECORD button
Depress to duplicate the tapes.
Also controls the record function
of al! additional printers con-
nected.
@ AC IN socket
© Before connecting, make sure that the POWER switch is OFF.
@® GND (ground) terminal
® CONTROL connector
@ LINE OUT connectors
These send the track signals of the original progran
to the addi-
tional printer.
@® LINE IN connectors
These accept the track signals from another masterp inter.
*
Advertisement
Table of Contents
