LG WD-14276RD Owner's Manual page 8

I nstallation
■Installation clearances
The location must be large enough to fully open
the washer door.
■ Washer dimensions
• Most installations require a minimum
10 cm clearance behind the washer.
■ Minimum installation spacing for
recessed area installation.
The following dimensions shown are for
the minimum spacing allowed.
Additional spacing should be considered
for installation and servicing.
• Additional clearances might be required
for wall, door and floor moldings.
• Additional spacing of 2.5 cm on all
sides of the washer is recommended to
reduce noise transfer.
Companion appliance spacing should also be
considered.
6
98.2 cm
■ Level floor
■ Power outlet
76.7 cm
[Vista lateral]
2.5 cm
68.6 cm
[Vista frontal]
• Allowable slope under entire
washer is 1°.
• To minimize noise and vibration,
the washer MUST be installed
on a solidly constructed floor.
• Wood floors may need to be
reinforced to reduce noise and
vibration.
• Carpeting and soft tile surfaces are
not recommended.
• Never install the washer on a
platform or weakly supported
structure.
Must be within 1.5 m of either side of
the washer. Do not overload the
outlet with more than one appliance.
2.5 cm