Table of Contents
Advertisement
aavancea
vperauuns
Using Alternate Power Sources
You can choose any of the following power sources for your camcorder: battery pack (P.6), house
current, and 12/24 V car battery. Choose the appropriate power source depending on where you want to
use your camcorder.
Aecesory tobe used
AC power adaptor AC-V25/V25A/V25B
(supplied), AC-S10, AC-V55
Battery pack NP-55 (supplied), NP-80, NP-80D,
Batiety pack
NP-77H, NP-66H, NP-60D, NP-5SH
12 V or 24 V car battery
DC pack DCP-77
Using House Current
To use the supplied AC-V25/A25A/V25B AC power adaptor:
(1) Lift up the viewfinder. (2) Connect the AC power cord to a wall outlet. Connect the bottom of the
AC power adaptor to the battery mounting surface of the camcorder. (3) Set the selector to VTR (DC
OUT).
fe
fo)
Notes on the POWER lamp
¢ The POWER lamp will remain lit for a while even if the unit is unplugged after use. This is normal.
¢ If the POWER lamp does not light, set the selector to the center position and disconnect the power
cord. After about one minute, reconnect the power cord and set the selector to VTR (DC OUT) again.
sanmnos
Jamog
ayeuayy
Buisp
/adel
e yoeg
BurAepy
To remove the adapter
The adaptor is removed in the same way as the battery pack. (p.8)
19
Advertisement
Table of Contents
