Table of Contents
Advertisement
| INSTALLATION
| MAINTENANCE
When
installing the deck, avoid jocations with high
temperatures
or humidity,
and
make
sure
that the
deck receives adequate ventilation.
@ Do not install the deck in locations subject to direct sunlight, or near a
space heater or other heating device, as this may cause damage to
the finish or the internal parts.
B
Maltunctions may also result if the deck is installed in an excessively
humid or dusty location.
Avoid installing the deck next to kitchen
counters or other locations subject to oily smoke or humidity
@
If the deck is placed directly on top of an amplifier, it may pick up
humming
or other noise.
Also, it the amplifier generates a large
amount of heat, the deck may malfunction.
@
Do not place a cloth over the deck, or block the ventilation slots in
any other way. The ventilation siots on this deck are necessary to
keep
internal
parts
cool.
If they
are
blocked,
the
deck
may
miatfunction.
CONDENSATION
(DEW)
When the deck is moved from a cold location to a warm location, or
when the temperature of the room changes suddenly, condensation (a
Phenomenon in which moisture forms on the surface of the mechanical
parts) may occur, This can adversely affect the performance of the deck.
In such cases, wait for about one hour to allow the deck to adjust to the
room temperature. To prevent condensation when heating a room, raise
the temperature siowly.
POWER-CORD CAUTION
Handie the power cord by the plug. Do not pull out the pfug by tug-
ging the cord and never touch the power cord when your hands
are wet as this could cause a short circuit or electric shock. Do not
place the unit, a piece of furniture, etc., on the power cord, or pinch
the cord. Never make a knot in the cord or tie it with other cords.
The power cords should be routed in such a way they are not like-
ly to be stepped on. A damaged power cord can cause fire or give
you an electrical shock. Check the power cord regularly. When you
find it damaged, ask your nearest PIONEER authorized service center
or your dealer for a replacement.
ues
B Cem, 2
a
se
aos
Combination head
Capstan
__Pinch roller
1
Set the POWER switch to STANDBY,
2
Press the EJECT button to open the cassette door.
NOTE:
After cleaning the head section, do not load a tape until the cleaning fluid
has dried completely {about 2 or 3 minutes).
3
<RRB1137>
En
Advertisement
Table of Contents
