Pioneer DC-888Z Operating Instructions Manual page 17

RECORDING MUTING
During recording you can make non-recorded passages
while listening to the input signal. Use this function to
create non-recorded portions of at least 4 seconds, which
are necessary for performing a music search.
When the tape arrives at the point
where a non-recorded portion is to be
created, depress the REC MUTING
switch (6 ) continuously.
After about 4 seconds, press the
PAUSE (ga ) switch while keeping the
REC MUTING switch depressed.
® The unit will go into a pause condition, and the PLAY
indicator will flash.
To resume recording, press the PAUSE
(g8 ) switch once again.
@ You can also use the PLAY switch instead of the
PAUSE (B@ ) switch.
lf you press the REC MUTING switch while recording is
taking place, a non-recorded portion will be created. Be care-
ful, therefore, not to depress the switch other than when ne-
cessary.
NOTE:
REC MUTING switch does not operate in tape copy mode.
|
4
Duplicating the recorded contents of one tape onto another
tape is known as tape copying. The contents of the tape in
deck | can be copied onto the tape in deck {I (but not vice
versa). Copying is not possible even if the COPY switch is
pressed while either deck is operating. You cannot record a
source using the graphic equalizer.
If a tape recorded with the Dolby NR system is copied,
the copied tape will also be recorded automatically with
Dolby NR system. If a tape recorded in the normal mode
is copied, the copied tape will also be recorded automat-
ically in the normal mode.
COPYING A TAPE WHILE LISTENING TO IT
| Press the POWER switch to the on po-
sition.
3 Select the REVERSE MODE switch.
REVERSE MODE switch
(=
4 Set the FUNCTION switch to TAPE.
Operation
One side is copied from
deck | to é
Both sides a r e copied from
deck | to deck I.
Double-sided recording
3)
® Deck | plays back while deck II records.
17
<ARB1072>