Advertisement
Available languages
Available languages
| nstallati on continued
@ Using the Rear Support Strap ©
Affix one end of the Rear Support Strap © to the rear of the unit, and the other end to the Fire Wall of Car,
or some other metallic area.
@® Plain Washer
Fire Wall of Car
f
@ Spring Washer
i
Gy Ot
et
"\. @® Toothed Lock Washer
@ Hex. Nut
S
@ Hex. Nut
®, @® Spring Washer
31
'\.® Plain Washer
"©
Rear Support Strap
.@ Mounting Collar
Using the Rubber Cushion (Optional)
(If there is an existing Rear Support Bracket on the Fire Wall of Car.)
Cover Mounting Bolt ® on the rear of the unit with Rubber Cushion (Optional), and mount it into the exist-
ing Rear Support Bracket.
Rear Support Bracket
(existing on the car)
Rubber Cushion (Optional) |
oe
—
Mounting Bolt
[i
a
oF
end
Pen
we
ee
|
@ Mounting Collar
E
Connector
3. Plug the Power Connector ©).
4. After installation reconnect the negative (-) battery terminal.
To Remove the Unit
When removing or installing the unit, make sure that it is in the ALARM OFF mode. (See page 19.)
a) Remove the trim plate with a screwdriver as shown in the figure.
Trim Plate
b) Pull out the unit while pushing the lock fever using a screwdriver.
c) Remove the unit pulling with both hands.
Screwdriver
Advertisement
