Advertisement
Available languages
Available languages
Installation
Preparation
© Before installation check the radio operation with antenna and speakers.
@ Disconnect the cable from the negative (-) battery terminal (see caution below).
Caution:
For installation to cars with trip or navigational computers, all electronic memory settings previously registered
in the computer will be lost when the battery terminal is disconnected. For this type of car, battery could not be
disconnected. Therefore, extra care should be taken to prevent short circuiting.
In-dash Installation
Installation Opening
In-dash installation can be done if the car's dash-
53 mm
board has an opening for this unit as shown in Fig.
1. The car's dashboard should have a thickness of
4.5mm - 6mm in order to make the installation of the .
cab
unit.
Fig. 1
installation Precautions
1. This system is to be used only in a 12-volt, DC battery system (car) with negative ground.
2. Foltow the electrical connection on page 54 or 55 carefully. Failure to do so may result in damage to the unit.
3. Connect the power lead after other connections are made.
4. Be sure to connect the YELLOW lead to the positive terminal (+) of the battery or fuse block (BAT) terminal.
5. Insulate all exposed wires to prevent short circuitting.
6, Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instructions of the respective equipment before connect-
ing it to this unit.
Supplied Hardwares
Mounting Collar
®
mm) Lock Washer
©)
1
® | Plain Washer (5 mmo)
iy
® | Mounting Bolt (5 mmo)
SS
1
i:
-
ap
@ | Spring Washer (5 mmo)
13)
@ | Power Connector
&
1
@ | Hex. Nut (5 mmo)
®
@
perenele Face Plate
LE
1
ase
&
=
a
;
fee
®) | Rear Support Strap
®
(Only for ROSSSLEN)
(es
1
+=
——}
© | Hex. Bott
q | Hom Alert
KS
'
(5 mmo x 25 mm)
| (Only for RDS45LEN)
{3
Installation Procedures
1. Secure the Mounting Collar @.
Insert Mounting Collar © into the car's dashboard, and bend mounting tabs out with a screwdriver.
@ Mounting Collar
Mounting Tab
2. Secure the rear of the unit.
a) Check the electrical connection by referring to this operating instructions.
b) Connect the Mounting Bolt ©, using a suitable wrench.
Mounting Bolt
Unit
//)
¢) Insert the unit into Mounting Collar @ and push it in until "click" is heard.
Advertisement
