Table of Contents
Advertisement
utions
[AWARNING|
To prevent injury or fire, take the
following precautions:
+ When extending the ignition, battery, or
'ground wires, make sure to use automotive-
(grade wires or other wires with a 0.7mm?
(AWG18) or mote to prevent wire
Beteriocation and damage to the wire coating
+ Ifthe unit stats to emit smoke or strange
'smells, turn off the power immediately and
Consult your Kenwood dealer,
The unit may break or crack because it
contains glass parts.
ACAUTION
To prevent damage to the machine,
take the following precautions:
* + Make sure to ground the unit to @ negative
12V DC power suppl.
+ Do not open the top or bottom covers of the
tnt.
* Do not install the unit in a spot exposed to
{ixect sunlight or excessive heat or humidity.
'Also avoid places with too much dust or the
possibilty of water splashing
+ Do not subject the faceplate to excessive
'shock, a8 itis a piece of precision equipment,
+ When replacing a fuse, only use a new one
with the prescribed rating. Using a fuse with
the wrong rating may cause your unit to
malfunction,
+ Do not use your own screws. Use only the
screws provided. If you use the wrong
screws, you could damage the unit,
IMPORTANT INFORMATION
You cannot connect the unit directly to the
following CD automatic changers. If you want
to use older changers with the unit, follow
the directions below according to the type of
'changer
you own:
'* KDC-C200
/ KDC-C300 / KDC-C400
Use the extension cable and the control box.
'attached to the CD changer, and the optional
'CA-DS100 converter cord,
Use the extension cable ettached to the CD
changer, and the optional CA-DS100
converter cod
'= KDC-C100
/ KDC-C302 / C205 /C705 /
'noe-enwood
CO changers,
Cannot be used with this model
ACAUTION
You can damage both your unit and
the CD changer
if you connect them
incorrectly.
Advertisement
Table of Contents
