Table of Contents
Advertisement
CD8112-1
1. Clutch shield
2. 5/16 NC x 3/4 Cap screw
3. 5/16 Lock washer
4. 5/16 Flat washer
5. Retaining ring
6. Shear bolt driveline
7. 1/2 NC x 3 Cap screw GR2
8. 1/2 NC Lock nut
Figure 14. Shear Bolt Driveline Assembly
SHIELDING REPAIR
DANGER
■ Full chain shielding must be installed when op-
erating in populated areas or other areas where
thrown objects could injure people or damage
property.
•
If the machine is not equipped with full chain
shielding, operation must be stopped.
•
This shielding is designed to reduce the risk
of thrown objects. The mower deck and pro-
tective devices cannot prevent all objects
from escaping the blade enclosure in every
mowing condition. It is possible for objects
to ricochet and escape, traveling as much as
300 feet (92m).
Rear Band
Inspect rear band each day of operation and replace if
bent, cracked or broken.
Rubber Shielding
Inspect rubber shielding each day of operation and re-
place if cracked or broken.
Optional Chain Shielding
Inspect chain shielding each day of operation and re-
place any broken or missing chains as required.
Inspect chain brackets and replace if bent, cracked, or
broken.
20 Owner Service
1
4 3
2
8
6
5
7
(GRADE 2)
CLEANING
After Each Use
After Each Use
■ Remove large debris such as clumps of dirt,
grass, crop residue, etc. from machine.
■ Inspect machine and replace worn or damaged
parts.
■ Replace any safety decals that are missing or
not readable.
Periodically or Before Extended Storage
■ Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
■ Remove the remainder using a low-pressure
water spray.
1. Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2. Be careful when spraying near chipped or scratched
paint as water spray can lift paint.
3. If a pressure washer is used, follow the advice of the
pressure washer manufacturer.
■ Inspect machine and replace worn or damaged
parts.
■ Sand down scratches and the edges of areas
of missing paint and coat with spray paint of
matching color.
■ Replace any safety decals that are missing or
not readable. See Safety Decals section for lo-
cation drawing.
MAN1298
( 08/01/2023 )
Advertisement
Table of Contents
