Yamaha FX500B Operation Manual page 24

■
Footswitch Memory Recall Range
Edit
The FX500B permits memory selection via an optional
Yamaha FC4 or FC5 fobtswitch connected to the
MEMORY INC/DEC TRIGGER footswitch jack (as long as
the footswitch is assigned to MEMORY INC/DEC operation
using the Footswitch Function Select function described
above). The Footswitch Memory Recall Range Edit
function permits setting the range of memory location
numbers that will be selected when the footswitch is
pressed.
I
F . S W M E M 0 R V R C L
' R R N 0 E 2
s
TCI
3 0
If, for example, the RANGE parameter is set to "20 TO 30"
as shown in the LCD illustration above, each time the
footswitch is pressed the next highest memory location will
be selected until the last number in the specified range is
reached. After the last number in the specified range, the
first (lowest) number is selected and the process repeated.
Reverse sequences can be programmed by entering the
highest number in the range before the lowest, as shown
below.
i F
. S Id M E M 0 R V R C L
' RfiNGE 34 TO 31
In this case the selection sequence is: 34 -»33 -»32 -* 31
-*
34, etc.
0 Use the UTILITY key to call the F.SW MEMORY RCL
display. The underline cursor should be located under
the first memory number in the range.
0 Use the Aand Ykeys to enter the first number in the
range.
0 Press the PARAM (►) key to move the cursor to the
second qumber in the range.
23
0 Use the Aand Tkeys to enter the second number in
the range. The MEMORY (◄) key can be used to
return to the first number in the range if necessary.